Hygiene Vital for Food Processors

Recent food scares remind processors: Pay attention to the basics of personnel hygiene.

By Dave Fusaro, Editor in Chief

Share Print Related RSS
Page 1 of 2 « Prev 1 | 2 View on one page

It seems there’s always something coming down the food contamination pike. Just as the public begins to forget E. coli in ground beef there’s salmonella in peanut butter. As the salmonella concerns fade, listeria turns up in deli meat.

All are good reasons for the increased focus on sanitation of all types in food and beverage plants. Along with the washdowns, clean-in-place systems and hazards analysis and critical control points (HACCP) programs, there is renewed emphasis on one of the basics of plant sanitation: personal hygiene.

From hand washing to boot scrubbing to clean uniforms, there are simple and largely individual efforts that food plant employees can make to ensure a safe food supply – and the continued success of their plant and their company.

Twenty Canadians died this past summer from listeria traced back to a Maple Leaf Foods deli meat plant in Toronto. How the listeria got into two of the plant’s slicing machines may never be fully understood, but spreading it by human contact is certainly a possibility. As of late October, the plant still had not reopened, despite test runs of food.

While listeria can be found in many, maybe most, plants if you look hard enough, it should never get above floor level. But, “It can be brought in or moved from one area to another on shoes or boots,” explains Michele Colbert, vice president of sales and marketing for Meritech Inc. (www.meritech.com), Golden, Colo. “Listeria can grow in the moisture on floors and in drains. Walking through puddles of water can spread it all over the plant.”

As a result, Meritech is seeing great interest in boot sanitizing systems. “Even just a year or two ago, some plants didn’t do this at all,” continues Colbert. “Now, many are at least making people walk through foam sanitizers in entrances from one area to another. The really concerned ones are installing automated boot scrubbing systems, which ensure a sufficient amount of cleaning and sanitizing.”

Still, she says, many food plants have not sufficiently addressed the contamination potential of footwear.

Equipment Supplier Offers Advice on 6-Point Hand-Washing Program

Simple hand washing is another issue. Hand washing has been a requirement forever. But making sure employees do it and do it right, that’s another issue.

Meritech suggests a six-point program:

  • Soap: Antimicrobial soaps should be available at all wash stations. Closed dispensers and automatic systems are recommended to prevent the spread of infection. Counters are necessary to track handwash performance.
  • Water: Temperature should be not too hot, not too cold: ideally around 100 degrees, to assist in both pathogen removal and employee comfort.
  • Towels: Single-use paper towels or an automated paper towel dispenser improve cleanliness by adding friction and thoroughly drying hands. Blow dryers have a tendency to leave hands damp, if they are used at all.
  • Sanitizer: Instant hand sanitizers or wipes should be used when handwashing is not immediately available. They should provide residual protection, ideally for several hours, to continue killing pathogens after the wash.
  • Schedules and Guidelines: Handwash guidelines should be established based on health department and/or HACCP recommendations.
  • Time and Convenience: Handwash stations should be conveniently located throughout the facility. In plants, multiple handwashing stations should be installed at the entrance of the plant and in areas to prevent cross contamination.

Meritech has a number of hand washing systems, from traditional stations to highly automated – and audited – ones. In the company’s CleanTech systems, employees insert their hands into separate cylinders simultaneously. Twelve seconds in this automated wash yields hands as clean as those that undergo 30 seconds of manual hand washing – if the manual hand washing is done properly.

Side-benefits of the system are less use of chemicals and water (75 percent less water) and faster processing of employees. Multiply that 18-second time reduction by a couple hundred workers and the manpower savings add up. “Plus, you know it’s done right,” Colbert emphasizes.

Meritech also has a walk-through hand and boot wash system, a 6-ft.-long series of automated stations that sanitize hands and boots in nonstop fashion. It can process 25 people a minute.

NSF International (formerly the National Sanitation Foundation) has the perspective of seeing best practices in many U.S. food plants … and many overseas. The level of employee hygiene in foreign plants may surprise some American food employees.

“I’ve been in Asian plants where it takes 15 minutes to get from the front door to the production floor because of all the safety and hygiene steps,” says Tom Chestnut, vice president of food safety and quality at NSF (www.nsf.org), Ann Arbor, Mich.

Page 1 of 2 « Prev 1 | 2 View on one page
Share Print Reprints Permissions

What are your comments?

You cannot post comments until you have logged in. Login Here.

Comments

No one has commented on this page yet.

RSS feed for comments on this page | RSS feed for all comments